KWA LM4 Top Dead Center (TDC) Hop Up Installation Guide
KWA LM4 TDC Hop Up Installation Guide Below you’ll find a complete installation guide to remove the stock hop shroud and replace it with this TDC unit. This task can be done in less than 5 minutes providing the outer barrel is already removed from the receiver. Parts Needed
LM4 TDC Hop Up Unit.
Tools Needed
2.5mm Hex Key (Size for M3 Set Screws)
Small Flat Head Screwdriver.
Guide and Hop-up created by Callum of H04. Hop-up units exclusively sold by Gas Blowback Central.Click here to buy one today!
Sign up for our Newsletter
Get a sneak peek on upcoming promos and get 10% off your first order!
Sign up today!
You can use this popup to promote newsletter signups, but that's not all! You could also omit the form and include action buttons linked to your pages and products instead. Or, use the popup to present an 'agree-to-terms' message that must be accepted before a visitor enters your shop!
